3D Blow Candle Teddy Bear Silicone Mould - 4 inch Two-Part Standing Bear in Party Hat for Birthday Cakes, Fondant, Clay and Candle Making

A fully three-dimensional bear that stands on the cake by itself - not a flat piece pressed onto the side. This is a two-part mould: you fill both halves, close them, let the piece set and peel the silicone back to release a complete figure with a finished back, sides and base. That is the difference between a topper a customer notices and one they walk past, and it is why a 3D mould costs more than a relief one. The sculpt is a bear standing in a party hat, head tipped forward, caught mid-blow over a candle - a pose with a story in it, which is exactly what a first-birthday or milestone cake needs and what a generic sitting bear cannot do. Fur texture runs across the whole body, the hat sits at an angle with a cord under the chin, and the face is soft and closed-eyed. At 4 inches it is substantial: a genuine centrepiece on a single tier rather than a small accent. The silicone is soft and very stretchable, which matters on a 3D mould more than any other kind - a stiff mould tears the ears and paws on the way out, while this peels back over the undercuts and releases cleanly. Works with fondant, gum paste, modelling chocolate and chocolate, and with polymer clay, resin, plaster, soap, wax and candle wax - the standing figure is popular as a nursery ornament and a moulded candle in its own right.

Key Features: Two-part 3D mould - produces a complete free-standing figure, not a flat relief piece | Finished back, sides and base, so it stands on the cake by itself | Distinctive pose: bear in a party hat blowing out a candle | 4 inch - a genuine centrepiece on a single tier | Fur texture across the whole body, angled hat with a chin cord | Very soft and stretchable silicone - peels back over ears and paws without tearing | For fondant, gum paste, chocolate, clay, resin, plaster, soap and candle wax | Also sells as a nursery ornament and a moulded candle